Kraton Hot Racing servo mount

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Fallguy

Active Member
Messages
262
Reaction score
309
Arrma RC's
  1. Felony
  2. Kraton 6s
  3. Senton 6s
  4. Typhon 6s
This is on a v4 6s Kraton. The mount seems to be sitting higher than stock. Is this ok? Nothing is touching or rubbing but the servo arm is not level.
 

Attachments

  • 20200124_213035.jpg
    20200124_213035.jpg
    128.6 KB · Views: 113
  • 20200124_213041.jpg
    20200124_213041.jpg
    190.2 KB · Views: 84
You could put a couple of washers or a plain m3 nut in between the link to raise it up and make it a little closer to parallel

Although it’s not an identical setup as yours, I’ve had to do this on several of mine
76987693-95C7-4937-9B65-81B46BAD6005.jpeg
 
You could put a couple of washers or a plain m3 nut in between the link to raise it up and make it a little closer to parallel

Good idea thanks. I just want to make sure I ordered the right one. Already ordered something else wrong. It seems a lot of people use these, just curious if anyone else ran into this.

* Just saw your edit and picture. Thanks!!
 
I just used some M3 plastic spacers not even sure where they came from. I also had to do the same thing on my D8T, I think that has like a 10mm spacer in there.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top