Hot Racing Steering Hubs - bearing question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Messages
68
Reaction score
62
Location
Orange County, CA
Arrma RC's
  1. Kraton 6s
Fellas,

Searched and could not locate the topic...bought the K6s HR front steering hubs. The inner bearing is oversized but outer bearing looks stock size. I have a set of Fast Eddy bearings for my truck. Would you swap out that outer HR bearing for the Fast Eddy, or just leave it?

(Wondering because I figure the right bearing is worth at least 5-10 mph...)
 
Fellas,

Searched and could not locate the topic...bought the K6s HR front steering hubs. The inner bearing is oversized but outer bearing looks stock size. I have a set of Fast Eddy bearings for my truck. Would you swap out that outer HR bearing for the Fast Eddy, or just leave it?

(Wondering because I figure the right bearing is worth at least 5-10 mph...)
I think the HR bearings are very similar to FE bearings. I ran the HR bearings and haven’t had an issue yet.
 
I took a closer look and I think they’re the same bearing. Seals look nearly identical, but the HR set didn’t have enough grease. Will pack in a little Phil’s Waterproof tonight and call it good. ???
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top