How do you 6S guys deal with wheels stripping/melting?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
It's not that, I literally just watched the wheel go flying off the car but the hex nut and everything else is still perfectly bolted on and in tact. It just shredded then melted the plastic wheel hub.
Just happened to me
My wheel melted
off with the nut still on the hub.
 
It’s the bearings 💯 replace them bearings I never ran my truck in wet conditions all I did was clean it a lot and from washing my dirty trucks after bashing I even use my air compressor to blow out still seized couple bearings upgrade bearings kit from Amazon and cut back on washing my rigs an so far so good
 
It’s the bearings 💯 replace them bearings I never ran my truck in wet conditions all I did was clean it a lot and from washing my dirty trucks after bashing I even use my air compressor to blow out still seized couple bearings upgrade bearings kit from Amazon and cut back on washing my rigs an so far so good
Thanks Mate 100% good info, have been washing down my mojave alot.
 
Good info. Having problems with my Talion and tires. I hose off the Talion after every run, might be time to check the bearings....
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top