Rainger40
Active Member
- Messages
- 799
- Reaction score
- 895
- Arrma RC's
- Granite
- Kraton EXB
- Senton 3s
Had this thing around a month now and only gotten one full pack out of it. It was pathetic the first run so I put 17t pinion and 500k in center diff. Livened things up nicely for all 5 mins of testing until the diff outdrive broke. Not on a 100’ jump at 50mph, but bounce over my driveway. Rear end came up, I hit throttle to bring it down and it breaks. Mind you this is slow speed and less than a foot off ground in rear. So I order and wait for parts, fix it up and take it out again today. All is going great, big jumps, wheelies, the works. Then like before a slow speed blip over a bump on a side of a jump I’m going to line up and hit, rear goes up, I throttle it down and same drive cup shattered again. So it’s breaking with rear up in air and front down on ground on throttle if that makes sense. I don’t know what to think. Droop is set, driveshafts aren’t hitting the cups at full droop or compression, there was no binding, I just don’t get it. My patience for “extreme bash” is about gone. Any suggestions here guys, this truck just isn’t fun anymore.
Last edited: