Infraction Infraction V2 with a few 3D printed mod's.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Messages
130
Reaction score
267
Location
Los Angeles
Arrma RC's
  1. Felony
  2. Infraction
  3. Mojave
  4. Raider
  5. Voltage
Hey guys, I thought I would show and tell my Infraction.

No hardware or power upgrades. Just some aerodynamics and such.

I printed magnetik's drag wing, looks so cool. Also his front wheel well skirts to help with the air drag underneath. In addition, I printed suchtragedy's 2-piece side skirts.

I printed magnetik's SkyRc GPS holder.

I drew up and printed a wing for the roof of the cab. Kinda like the wings you see on semi-tractor trucks. I just thought it would look cool and I imagine it would help in a speed run. I printed up a set of magnetik's roof skids, modified a bit, to attach the wing.

Lastly I printed up some louvers, actually designed for front fenders and brake cooling. However, I attached them to the top of the bed rails. I still need to cut out the body area underneath the louvers, and the idea is to help vent some heat out from the electronics.

Oh, and a line up of three of my RC vehicles out at the park today.

:)

20201101_113801 (Copy).jpg


CIMG5865 (Copy).jpg


20201001_124627 (Copy).jpg


20200920_144738 (Copy).jpg


20200918_152140 (Copy).jpg


20200926_162632 (Copy).jpg


20210219_152140.jpg


20210219_152147.jpg


20210220_095825.jpg


20210220_095845.jpg
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top