Granite install brushless motor

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Hello

I don't have a 20 t pinion. I have 14,15,16 and 17t.
Can I try any of these or only with the 20t
Slipper sounds too loose to me. Also you can go up on your pinion size. The 3660 3300 is close to stock 3s BLX (3660 3200kv) which uses a 20t pinion. So try tightening up the slipper and going a few teeth up more on the pinion.


Hello

I don't have a 20 t pinion. I have 14,15,16 and 17t.
Can I try any of these or only with the 20t
 
Last edited:
Try the 17T and tighten your slipper and see how it runs. You probably want to find a 20T at some point. They’re cheap.
 
Hello

friend can I install any of these in my mega senton or not recommended? or is there not for this model that I have?

MAV
 
I don’t know of any chassis upgrades for the plastic chassis Arrma rigs.
 
Hello
They offer me this engine. Can it be used in my mega senton?
"team orion 2500kv"
 
Hello
They offer me this engine. Can it be used in my mega senton?
"team orion 2500kv"

I'm gonna say no that's a 43mm dia 70mm long can motor overkill motor for the 3s/Mega Senton and with that large diameter probably won't fit. I would stay with 36mm diameter can motors but that's just me.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top