Fazon Is there a receiver for the arrma atx 101?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

RL256

Fairly New Member
Messages
22
Reaction score
16
Arrma RC's
  1. Fazon
  2. Voltage
Hi. I want to upgrade my boys Voltages to brushless. I’d like to keep to stock ATX 101 transmitter if possible. But obviously the mega SRS 3-1 will be gone, so I will need a separate receiver. Is there an arrma receiver that will link to it?
 
No known Arrma receiver. I did get it to bind to a Ikonnik KNNS0026 receiver that came with my Ikonnik ET3 transmitter in my Helion Avenge MT.
 
No known Arrma receiver. I did get it to bind to a Ikonnik KNNS0026 receiver that came with my Ikonnik ET3 transmitter in my Helion Avenge MT.
Thank you. That’s what I’m looking for
 
I’ve already changed both servos to 3 wire. The stock ones are crap
 
Will this work with the atx101
 

Attachments

  • Screenshot_20200614-085141_eBay.jpg
    Screenshot_20200614-085141_eBay.jpg
    109.3 KB · Views: 89
I did it and it don't work

Try this should be the same to bind as the Ikonnik ET-3

1. With the transmitter in close proximity but not closer than 300mm to the
receiver, press and hold the PAIR / BIND button on the receiver then
switch the receiver ON. The receiver’s LED will flash to indicate that it is in
PAIR / BIND mode.
2. Press and hold the PAIR / BIND button on the transmitter then switch
the transmitter on. The transmitter’s LED will begin to flash.
3. When the LED on the transmitter and receiver stop flashing and light solid
red, your ET3 transmitter and receiver will be bound / paired. You will now
have full control of any channels that are connected.
 
I bought a mt305 and I was able to successfully pair it with the Arrma atx-101. Turn on the atx-101. Press and hold the bind button on the mt305 and turn on the RC vehicle and release the bind button on the receiver. The LED should be blinking on the receiver. Press and hold the bind button on the atx-101 until the LED on the transmitter starts to blink. The LED on the atx-101 should blink for a few seconds. The LED on both the atx-101 and the mt305 should now be solid and they are paired. Works fine in my test for both throttle and steering with no need to reverse either one. If you have a Granite Voltage and end up wanting or needing to replace the electronics, the mt305 is a cheap way to get a receiver without having to buy a new transmitter.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top