KevinC
Flyboy, Cat Hoarder, Tiger Tamer, Party Crasher.
Lifetime Premium!
Premium Member
Build Thread Contributor
- Messages
- 2,346
- Reaction score
- 4,034
- Location
- Brantford,Ontario
- Arrma RC's
- Fireteam
- Limitless
- Kraton 8S
- Kraton 6s
- Kraton EXB
- Mojave EXB
- Talion
- Talion EXB
Today I went over all the diffs. Didnt go crazy, just pulled them apart and topped up with thicker juices.
The Center drive shafts were slightly bent out of the box but within limits I guess.
Hot racing wheel nuts are not serrated......take note. M2C 2mm thingies forthcoming I think.
Buttoned up all screws.
Printed a few of @suchtragedy bits and pieces.
Sticker job sucks,,,,I hate stickers anyways so most of them are gone.
Spektrum 160A with the 1250 Kv motor are going in, 21T for now. I plan on running 8S. Some guys are running “blind nuts” in their battery tray for added security.......can someone post how they do this?
Going to install two 3D printed “pinhead” drivers from the movie Hellraiser. Scary....
The Center drive shafts were slightly bent out of the box but within limits I guess.
Hot racing wheel nuts are not serrated......take note. M2C 2mm thingies forthcoming I think.
Buttoned up all screws.
Printed a few of @suchtragedy bits and pieces.
Sticker job sucks,,,,I hate stickers anyways so most of them are gone.
Spektrum 160A with the 1250 Kv motor are going in, 21T for now. I plan on running 8S. Some guys are running “blind nuts” in their battery tray for added security.......can someone post how they do this?
Going to install two 3D printed “pinhead” drivers from the movie Hellraiser. Scary....