Outcast Kimbrough servo saver

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Ben_W2503

Fairly New Member
Messages
24
Reaction score
12
Arrma RC's
  1. Outcast 4s
Hi Guys!
hope you can help me. I bought the heavy duty servo saver from Kimbrough (Part-Number: KB124) but i'm not sure how to install the servoarm on it. the stock one has two... (i don't know how to say in english) where you can put the arm in between. the kimbrouogh don't has this. and i think i have to cut the edges...
any advice is much apreciated!
Thx in advance
 

Attachments

  • IMG_20200619_122037.jpg
    IMG_20200619_122037.jpg
    164.3 KB · Views: 114
You are correct, you have to cut the edges so it looks like the factory servo saver.. then just line it up and put the screw in...

No worries about the difference in the ear count.. the arm just mounts to the single ear on the 124..?
 
Under...towards the spline side..?.. just like the factory saver, just one less ear.. ✌
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top