Kraton EXB, Rear Diff Housing - Remove MAIN INPUT GEAR?

[RC Arthurs]

I need to replace AR310854 GEARBOX CASE SET HD. AKA Rear diff casing.
So I have three parts remaining to be removed and I can't figure out how to remove ARA310979 MAIN INPUT GEAR, ARA310976 INPUT SHAFT CUP SLEEVE, and last but not least ARA310977 INPUT SHAFT CUP (SAFE-D).

I've already removed ARA724406 Set Screw M4x6mm. But I can't figure out how to remove the rest of it the parts detailed above.

Thanks!
-Matt

 

[elschizo]

Push the pinion through from the front.

 

[RC Arthurs]

Push the pinion through from the front.

I have tried wedging it out with a flat screw driver, even tapping it (lightly) with no luck.
Just to confirm, within the diff case, all I have to do is push the pinion out? I'm just concerned as I've already damaged a screw driver without a little budge from the pinion. Thanks!

 

[jondilly1974]

Once you remove the set screw from the input cup, it should just slide off. Mine have all just fallen off as the screw was loosened. ??‍

 

[RC Arthurs]

With some serious wrenching, I was able to finally remove it using a dual pick screw driver. Thanks everyone!

 

[Surchaufeur]

With some serious wrenching, I was able to finally remove it using a dual pick screw driver. Thanks everyone!

Yeah clean it off man it was flooded with threadlock