Kraton Kraton Upgrades!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Pfaulk54271

Very Active Member
Messages
381
Reaction score
804
Location
Parrish, FL
Arrma RC's
  1. Talion
  2. Voltage
  3. Notorious
  4. BigRock 4x4
Finally got the last piece to complete the perfect center diff, my m2c motor mount! This should be really nice once finished up. ?
*Edit
Also doing the temp probe on the TP 4070 and a hybrid ceramic bearing.

20190508_212608.jpg
 
Last edited:
how or where are you gonna mount the sensor I'm really digging it if it reads on the controller
I'm not really sure yet, it looks like some foil tape is provided for installation. If anyone has any other ideas on mounting the probe let me know.
 
where are u mounting the prob on the diff ?
I'd want the probe on my motor or esc ... better yet both if possible if this reads on your controller I want to know what your using cause I'm about to buy it I hate checking temps if I can see it live on my controller I'm sold already
 
I'd want the probe on my motor or esc ... better yet both if possible if this reads on your controller I want to know what your using cause I'm about to buy it I hate checking temps if I can see it live on my controller I'm sold already
Futaba 4pv, I haven't used their telemetry yet but it will be nice to have. I will still probe the motor by hand at first to make sure it is reading properly, don't want to burn this beauty up.
 

Attachments

  • 20190311_220638.jpg
    20190311_220638.jpg
    465.2 KB · Views: 60
I don't blame you but if it's even close I'm all in on this one iv been looking into getting a futaba but I had no idea this was an option
 
I'd want the probe on my motor or esc ... better yet both if possible if this reads on your controller I want to know what your using cause I'm about to buy it I hate checking temps if I can see it live on my controller I'm sold already
so the 4px is calling my name lol just gonna do some shopping around I guess see where I can get the best deal
 
the kill mode motor is it just for speed runs or how does it compare to the motor you have
I'm sure as long as you gear it properly you could use it for regular bashing, these 4070 cans are almost too long to be jumping with though. I've backflipped mine a few times and had a few decent airs but I'm worried everytime I do it. Honestly your best bet might be the TP 4060 motor, it would still have insane power and its a little lighter.
 
Feast your eyes ?
 

Attachments

  • 20190519_195508.jpg
    20190519_195508.jpg
    265 KB · Views: 44
  • 20190519_195504.jpg
    20190519_195504.jpg
    248.2 KB · Views: 49
  • 20190519_195531.jpg
    20190519_195531.jpg
    269.8 KB · Views: 48
  • 20190519_195615.jpg
    20190519_195615.jpg
    286 KB · Views: 43
  • 20190519_195520.jpg
    20190519_195520.jpg
    289.5 KB · Views: 40
  • 20190519_200110.jpg
    20190519_200110.jpg
    262.9 KB · Views: 45
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top