Limitless V2 spool can use saga gears?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

justin080

Active Member
Messages
194
Reaction score
205
Location
Germany, Meppen
Arrma RC's
  1. Limitless
  2. Typhon 6s
  3. Typhon TLR
Can you use saga gears with the v2 spool while the spool has no flat spot? no i don't want to cut in there.
Just want to know if its possible for a range of teeth with the stock set screw or if not :)


thank you,
dear justin :)
 
Yes you can use Saga gears. There is a flat spot on the spool shaft. You will need to work up spacers though because the Saga pinions are different than the Arrma factory gears.
thank you.
is it possible to use m5 grub screw saga gears on the v2 spool flat spot?
also do u know what for spacers i need ? will it be enough to buy the spacers from v2 so that i have them 2 times ?


dear justin.
 
thank you.
is it possible to use m5 grub screw saga gears on the v2 spool flat spot?
also do u know what for spacers i need ? will it be enough to buy the spacers from v2 so that i have them 2 times ?


dear justin.
What you could try is, go to your local hardware store and see if they have any aluminum tubing with an 8mm ID. Then just cut your own as needed.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top