Losi DB cage on typhon

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
It fits on a tekno easily...but this is on my typhon
As you can see the front fenders would need to be cut off for servo arm to turn, front body mount will line up, the rear shock tower you would have to drill holes. This typhon is stretched so hard to say...what length is the cage and 3s typhon

16233018261843834471979067907641.jpg


16233018829466030324767579026058.jpg
 
Yes it fits the Typhon 3s but you need to trim the side guards and make your own mounts.

I would not recommend using the method I used to mount the rear of the body, the aluminum isn't thick enough and it bends.

20200511_145654.jpg
20200511_145841.jpg
20200512_011354.jpg
20200512_005720.jpg


There was another member on here who did this at the same time I did and his method looked to be much better, I will see if I can find a link to the post.
 
Last edited:
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top