Lost PIN of Rear STEEL DIFF OUTDRIVE UNIVERSAL JOINT

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Jbeginner

Fairly New Member
Messages
9
Reaction score
0
Location
Hyogo, Japan
Arrma RC's
  1. Nero
  2. Senton 6s
Hello everyone.
I have lost a pin of Rear STEEL DIFF OUTDRIVE UNIVERSAL JOINT(#AR310555) in my firstrun.
I think the Initial failure, but Too lazy to contact the store because It was imported to Japan.
What size is it? 2.25mm x 11.8mm?(related to the inch?)
How to fix it? Instant adhesive?
Please give me advice.

There is nothing of a good diameter and I tried a nail and a paper clip at the same time.
I bent both ends to prevent falling out.
tentatively OK, but Someday it will be broken.
 

Attachments

  • DSC_1048.JPG
    DSC_1048.JPG
    280.4 KB · Views: 63
Hello everyone.
I have lost a pin of Rear STEEL DIFF OUTDRIVE UNIVERSAL JOINT(#AR310555) in my firstrun.
I think the Initial failure, but Too lazy to contact the store because It was imported to Japan.
What size is it? 2.25mm x 11.8mm?(related to the inch?)
How to fix it? Instant adhesive?
Please give me advice.

There is nothing of a good diameter and I tried a nail and a paper clip at the same time.
I bent both ends to prevent falling out.
tentatively OK, but Someday it will be broken.


yeah...i don't have mine with me..a soring roll pin may work...but 2 places to try for a short term fix...

try lowes or homedepot...and look for a spring roll pin..

or if you have a fastenal store in your area...they would be most helpfull in finding something for you...again...a temporary fix...not sure how long it would hold up...you squeeze the pin on the outer ends so it will fit tightly in the diff outer drive joints but loosely in the ears of the shaft yoke...
 
I appreciate your kind response.
I went to a home improvement center like homedepot.
I knew spring roll pin for the first time, I found it but there is no good size.
I purchased M2 bolt and 2mm cotter pin.
I will try them and see how it goes.
But the interspace between 2.25mm and 2mm accelerate gall of bolt or pin.
(STEEL DIFF OUTDRIVE UNIVERSAL JOINT(#AR310555) is made of high-quality steel ,and i believe it have good keeping. )
 

Attachments

  • DSC_1049.JPG
    DSC_1049.JPG
    232 KB · Views: 38
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top