Low Volt Protection on Nero's BLX200 ESC

[craig72]

Another ESC question about the BLX200 that came with my new Nero.
I did not see anything in the manual about low voltage protection. Does anyone have info on this? Is there anything programmable, and does anyone know the cutoff voltage or what indication I might get? On my first run, I just used my two buzzers set at 3.6v to be safe, but was curious if there was anything built into the ESC and if it might be configurable.

Thanks!

 

[Howdy2u2]

According to the ARRMA web site (You are Correct- NOTHING in manual!?!?!)

LVC is 3.2v/ cell (Nothing I have read about being able to change configuration either)

http://www.arrma-rc.com/power-systems/latest/blx200

According the the ESC spec sheet there is a 2 stage Lipo cut off, when or how it does it is a mystery................

http://www.arrma-rc.com/part/AR390173

 

[craig72]

Thanks, that helps. 3.2v seems a bit low. Guess I'll stick with the buzzers

 

[Howdy2u2]

Thanks, that helps. 3.2v seems a bit low. Guess I'll stick with the buzzers

Same!!!!