bicketybam
Back from vacation!
Lifetime Premium!
Premium Member
Excellence Award
Build Thread Contributor
- Messages
- 13,394
- Reaction score
- 23,196
- Location
- New Milford, CT
- Arrma RC's
- BigRock 4x4
- Granite
- Infraction
- Kraton 8S
- Kraton 6s
- Kraton 4s
- Mojave
- Notorious
- Talion
- Typhon 6s
I picked up the 3254 motor slide from M2C so I can run a 44t pinion with the M2C motor mount in my K8S. I have a few issues that I need help or opinions on.
1. They tapped one of the screw holes way too deep and it ran into to hope used to mount the motor to the plate. You will have to explain and the picture but you can see it. Is this a big deal? Will it weaken the attachment point?
2. There is an imperfection on top of the slide.
It kind if bothers me. Should it?
3. Unless I am doing something wrong, I have one screw hole for the top of the slide and two for the bottom. This doesn't make sense to me. Do I have the slide orientated the correct way?
Top hole
Two on the bottom:
What do you guys think? Thanks!
1. They tapped one of the screw holes way too deep and it ran into to hope used to mount the motor to the plate. You will have to explain and the picture but you can see it. Is this a big deal? Will it weaken the attachment point?
2. There is an imperfection on top of the slide.
It kind if bothers me. Should it?
3. Unless I am doing something wrong, I have one screw hole for the top of the slide and two for the bottom. This doesn't make sense to me. Do I have the slide orientated the correct way?
Top hole
Two on the bottom:
What do you guys think? Thanks!