M2C Rear Tower & Brace install

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

arrmigo

Fairly New Member
Messages
30
Reaction score
16
Location
Australia
Arrma RC's
  1. Kraton 6s
Hi All,
Have just installed M2C Chassis, Chassis Braces, Shock Towers & Rear Tower Brace. I have removed T2T Brace but was wondering if I should be keeping rear T2T mount? The mount that attaches to bulkhead & stock rear chassis brace. Can’t see it being beneficial now except to add a bit of inboard support to rear tower down low?
Cheers
 
Hi All,
Have just installed M2C Chassis, Chassis Braces, Shock Towers & Rear Tower Brace. I have removed T2T Brace but was wondering if I should be keeping rear T2T mount? The mount that attaches to bulkhead & stock rear chassis brace. Can’t see it being beneficial now except to add a bit of inboard support to rear tower down low?
Cheers
I don't see anything wrong with taking it off but I left mine on just in case I want put it back on.
 
Leave it in place. It keeps the Bulkhead square and tight and stronger.
What if any advantage would there be by removing it? You have to ask yourself.;)
 
Leave it in place. It keeps the Bulkhead square and tight and stronger.
What if any advantage would there be by removing it? You have to ask yourself.;)
Cheers mate. Reinstalled today after your advice. Much appreciated
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top