Max 6 outcast

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Slicktmi

Active Member
Messages
601
Reaction score
438
Arrma RC's
How are you guys mounting the max 6 in the outcast? I was just going to remove the center roll cage and mount it there but not sure?
 
If you figure it out, post up pics please. I didn't know it was that much bigger than the stock esc.
I am curious to see as well. I plan to pick up a hex6 (max6 but electronically limited to 6s, only $100!!!)
 
I got it too fit but mild trimming is needed I'll post pictures shortly
 
You gotta trim old switch holder off and also a little ridge on the mounting plate and it fits nicely tight fit but a nice tight!
 

Attachments

  • 20190111_202728.jpg
    20190111_202728.jpg
    428.7 KB · Views: 62
  • 20190111_202754.jpg
    20190111_202754.jpg
    227.6 KB · Views: 62
  • 20190111_210320.jpg
    20190111_210320.jpg
    279.5 KB · Views: 66
  • 20190111_210355.jpg
    20190111_210355.jpg
    305.6 KB · Views: 66
Snug fit. What truck is that?

EDIT:
Just noticed, your the guy that started the thread, so guessing an outcast. Did you have to leave the center tower thing off or were you able to put it back on after getting the esc in there?
 
Snug fit. What truck is that?

EDIT:
Just noticed, your the guy that started the thread, so guessing an outcast. Did you have to leave the center tower thing off or were you able to put it back on after getting the esc in there?
It was able to go back on i just left it off my body is all destroyed anyway and i cut the esc battery leads a little short so it was kinda in the way lol. Yeah it's a outcast
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top