Typhon Mmx esc fan

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Messages
2,015
Reaction score
1,786
Location
San Diego, ca
Arrma RC's
  1. Typhon 6s
So I installed mmx combo 2200
Few runs in damn fan no working but everything is correct do those funky little clamps burn out?

I know anything is possible but will it work if I installed yeah racing fan on esc and solder new clamp on will that fry esc?
 

Attachments

  • image.jpg
    image.jpg
    295 KB · Views: 53
I don’t see why it wouldn’t. Do you have a stock replacement? If not and the new one has a longer wire I’d just run it to the Rx. This way it stays on versus kicking on at 180F.
Or you can get an extension
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top