Typhon Motor assembly question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

palmryde

Active Member
Messages
260
Reaction score
279
Arrma RC's
  1. BigRock 4x4
  2. Granite
  3. Typhon 6s
Hello All, This weekend went to replace the bearings om 6s stock typhon motor. Puled the end caps off, set the motor on the bench and went inside for dinner. When i came out the motor had rolled off onto the floor. I am not sure if I found all the pieces/spacers and spring washers. I have 2 spring washers and a alum spacer about 1/4 inch long. What else am I missing? And does someone have a pic of an intact rotor so I can see how it all goes back together?
 
That should be all there was.. 2 spring washers, 1 spacer..

Washer against rotor.. u side up, spacer, then spring washer #2 u side down towards spacer.. I've seen them assembled many different ways.. but this is how I typically set them back up...👍
 
That should be all there was.. 2 spring washers, 1 spacer..

Washer against rotor.. u side up, spacer, then spring washer #2 u side down towards spacer.. I've seen them assembled many different ways.. but this is how I typically set them back up...👍
Great thank you
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top