Hey guys, I just got my new Typhon body and it looks good! However, I am having trouble mounting it under the body. Is the someway I could take out the receiver box? I know the servo is attached to it, but is it possible?
Typhon Mounting BLX185 (under typhon body)
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
SrC
RC is a lifestyle choice
Lifetime Premium!
Premium Member
Excellence Award
Hospitality Award
Build Thread Contributor
- Messages
- 22,472
- Reaction score
- 30,869
- Location
- Queens, NYC
- Arrma RC's
- Fireteam
- Infraction
- Limitless
- Kraton 6s
- Mojave
- Notorious
- Outcast 6s
- Typhon TLR
I imagine you would have to disect the Rx box from the Servo mount. Use another RX box or the original placed elsewhere, or just leave the RX out of the box and mounted with tape somewhere safe and away from the lipo leads (only if you are sure its a water resistant Rx if it matters to you.) Maybe place the ESC on its side as one alternative??
I have seen it done before somewhere. ?
Others hopefully will chime in with better knowledge.
I have seen it done before somewhere. ?
Others hopefully will chime in with better knowledge.
Last edited:
Not mine - but try this: https://www.thingiverse.com/thing:4652227
- Thread starter
- #4
Forgot to mention a 6s motor is also going in. I think I'm just going to try to direct. But If I do the there will only be 2 screws holding it in. Could I get a k6s metal servo mount and drill custom holes?
