My brushless revo 2.0 just got more arrma in it...

[olds97_lss]

Bought a new set of backflip MT's for the revo. Since they are lighter than the trencher 3.8's, I was going to change the gearing from 54/20 to 54/21, but the only 21T pinion I have looks like I used it to grind concrete... so will have to wait for the new ones I just ordered and leave it home tomorrow.

So now has an arrma blx2050kv 4074 motor on it and arrma wheels/tires.

Got them wrapped with 500lb cored kevlar cord and vented the tires.

The hot racing +10mm hubs means I keep the width I had with the trenchers.
Old tires:

The rears were really out of balance, not 100% sure why and stupid me forgot to mark them before taking them off... two are weighted with clay and two with lead weights/tape. I have another full set of trenchers on hand, so will just throw these on the back of the shelf and switch to the other trenchers for winter when needed.

 

[jkflow]

Funny, my Arrma's are barely 20% Arrma
Exception being the Infraction, thats probably 80%. Tires, servo and fans are not stock.

 

[Outcastblxnut]

M2c all I can say. Wish they sold stocks n bonds

 

[olds97_lss]

Funny, my Arrma's are barely 20% Arrma
Exception being the Infraction, thats probably 80%. Tires, servo and fans are not stock.

My outcast isn't very arrma anymore either...
Tires/wheels
CVD's/Center bones
Axle carriers
Diff cases/bulkheads, Diff gears/cups/internal gears/output drives (shims are mugen, bearings are FE)
Top steering plate, steering posts and slave bell arm.
Tierods/ends/turnbuckles
Battery tray
Side skirts
Center body cage thing
Shocks/ends.
Some of the screws.
Body mount holders (posts are RPM)
Rear bed roof rack thingy

The rest is aftermarket:
Arms
Chassis
Towers
Rear tower brace
Bumper front/wheelie bar rear
Wing mount/wing block
Wing mount brace
Center braces
Motor mount/center diff front piece and top
Motor/esc
Bearings (mix of TRB and FE)
Cooling fans
Body
HR servo saver
Servo
Servo mount