Kraton my fix for short shock springs

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

weldit

Member
Messages
4
Reaction score
9
Location
uk
Arrma RC's
here is my fix
20170905_155410.jpg


20170905_154516.jpg 20170905_154701.jpg
 

Attachments

  • 20170905_154516.jpg
    20170905_154516.jpg
    114.1 KB · Views: 48
  • 20170905_154516.jpg
    20170905_154516.jpg
    114.1 KB · Views: 53
  • 20170905_154516.jpg
    20170905_154516.jpg
    114.1 KB · Views: 48
  • 20170905_154648.jpg
    20170905_154648.jpg
    135.3 KB · Views: 51
Nice job man. Was hoping you bought these somewhere lol. Might need a set for the back shocks.
 
sorry mate but not hard to make if you access to a lathe
 
I once didn't have one also but I went and purchased one about 20 years ago. Still use it often. Taig Micro Lathe.... Great for RC repairs. Nice job !!!
 
had my first good run with this today, yes love it still got the same soft spring feel to it but with better ground clearance
very happy so far
 
Much easier and probably cheaper to just buy longer springs. I use Tekno 90mm truggy springs in front and rear.
 
Tekno Orange front and rear worked well. Why stop there....just install Tekno shocks. These shocks will take major abuse and not bust. Stuff will stretch when it normally would have snapped. Like the shock end link. I had a major bad landing and it stretched. I still used it till my new ones came in the mail. It never cracked.
 
Last edited:
Tekno Orange front and rear worked well. Why stop there....just install Tekno shocks. These shocks will take major abuse and not bust. Stuff will stretch when it normally would have snapped. Like the shock end link. I had a major bad landing and it stretched. I still used it till my new ones came in the mail. It never cracked.
I'd love to but unfortunately I have to replace a set of batteries and my budget stops there lol. Maybe eventually I'll get my hands on some.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top