My rig so far

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Trickelitrick

Active Member
Messages
237
Reaction score
192
Location
Sweden
Arrma RC's
So here are my current upgrades etc:
  • Fast eddy bearings everywhere
  • Tekno orange springs all around
  • GKA chassis braces and servo mount
  • tower to tower braces by @Mike Foucart
  • Savox 1210sg
  • hobbywing heatsink combo c4
  • RPM wing mount
  • RPM front bumper
  • tall sideguards
  • TBR wheeliebar
  • TBR mudguards
  • Proline 6" ledbar
  • Proline badlands mx38 just taped them
  • Dusty motors shroud cover and black socks on shocks behind springs
  • HR center diff carrier
  • ESC warranty replaced with hobbywing wp8 bl150
Right now waiting for a replacement receiver as well cause its dead since the ESC incident so here is what it looks like right now.

20170505_103916.jpg
 
Last edited:
locked the center and got many issues in front and rear diff....had to find the right thickness on the outer shims, in my case i ended up with a total of 0.9mm left front and left rear, two 0.2mm and one 0.5mm. now there is no slack and it spins very smooth as well :)
 
Tx for pimping my post mate :)

also the front dirtguards inside the body but i removed them because i believe i need that airflow
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top