Typhon My stock camber differs from the manual

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Yonic

Very Active Member
Build Thread Contributor
Messages
2,499
Reaction score
2,687
Location
Tel Aviv, Israel
Arrma RC's
  1. Granite
  2. Senton 3s
  3. Talion
  4. Typhon 6s
  5. Typhon 3s
  6. Voltage
Hello,
Just noticed that the front camber setting on my Typhon doesn't match the exploded view, and i wanted to ask how your Typhon came stock.

The exploded view specifies two clips on the top arm, but none on the lower.
My Typhon setting from the factory is one clip on the lower arm, and none on the top.

Is mine an error? how did yours came?
 

Attachments

  • Camber.png
    Camber.png
    362.4 KB · Views: 61
I can't answer how many or how thick where, out of the box but I would not count on that as being correct. Production tollerences and care during assembly doesn't appear to be stellar on any RTR. What matters is the result. Typically you should be in the 2-3 degree negative range, but what you ultimately need depends on the surface, tires and driving style. There is no correct standard setting, per se.
 
Hello,
Just noticed that the front camber setting on my Typhon doesn't match the exploded view, and i wanted to ask how your Typhon came stock.

The exploded view specifies two clips on the top arm, but none on the lower.
My Typhon setting from the factory is one clip on the lower arm, and none on the top.

Is mine an error? how did yours came?

I got my Typhon v3 a couple of weeks ago.
Like yours, no spacer on top. One on the bottom at each side.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top