in the front of my senton, there are these two pins keeping the the two front y-arms together. One is stuck and I have tried using pliers to remove it. I do wonder if the broken y-arm which I am trying to remove is causing the pin to jam. The y arm is fractured in the back and somehow the front slipped out of the pin. Is there anything I could do to remove it?
Need help removing the for Front Y-Arm pin in Senton 3s BLX 4x4
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 5,364
- Reaction score
- 8,339
- Arrma RC's
- Felony
- Kraton EXB
- Senton 3s
You got the bottom skid plate off and the bulk head front brace off!? Your gonna have to disassemble it a little!!
- Messages
- 5,364
- Reaction score
- 8,339
- Arrma RC's
- Felony
- Kraton EXB
- Senton 3s
Yea if its stuck that bad then it must be bent!?
Should slide right out!?
Should slide right out!?
Velodromed
Snatching defeat from the jaws of victory!
Premium Member
Excellence Award
Build Thread Contributor
- Messages
- 7,755
- Reaction score
- 13,913
- Location
- San Antonio, TX
- Arrma RC's
- BigRock 4x4
- Granite
- Kraton 6s
- Kraton 4s
- Notorious
- Outcast 4s
- Vorteks
- Voltage
- Infraction 4x4
If there is enough of the pin showing that you can put the drill chuck tip around it you can spin it out on low speed. I have also used a broken 1.5 millimeter hex driver to punch it out from the other side using light hammer taps. Can put a bit of lube in there also.
