Nero not turning...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Rchrdjrz

Active Member
Messages
116
Reaction score
35
Arrma RC's
  1. Nero
Hey guys I've been running my Nero for a few months now and it was running great.
I just finished replacing the stock servo for a much stronger one, because the stock one burned out. But I noticed that the wheels do not go back to neutral or straight after turning in either direction.
If I pick up the Nero from the ground and turn the wheels left or right they turn perfectly. But when I put it on the floor the wheels will not turn so smoothly unless I'm driving it. On a standstill, if I turn left or right the the wheels turn but then they don't go back straight or neutral. They kind of just move back a little bit. I tighten the servo horn and made sure that my new servo was working good.
 
Check your servo saver and make sure it's tightened down. Clockwise to tighten.
1488417781904-896208340.jpg
 
No just tighten the big red wheel. The screw is just there to hold everything in place. Good luck and let us know if it helped :)
 
No just tighten the big red wheel. The screw is just there to hold everything in place. Good luck and let us know if it helped :)
Thanks for your help. I'll try it when I get home.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top