Typhon New PB Typhon 6S GT 137mph

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Very nice! That's the first time I've seen the Proline "Chiron" body used; did you have to reinforce it?
I only used some gorilla tape around the body posts to protect the paint. Otherwise no other reinforcement needed. It’s a pretty decent body so far. My paint job didn’t turn out very good, but it’s a speed runner and not a shelf queen ?????
 
1B33FC8A-32A7-47BB-8859-93426E4E1CAA.jpeg
 
Thanks guys. I’m waiting on a bigger pinion to make the final pass on this setup. Shooting for the 40’s. Then it will be time to go to a new motor as this 1250kv can just doesn’t spin fast enough on 8S and my pinion is already a pizza cutter size and the spool spur is small too. I have a TP on the way, prob the end of this month. I might grab a cheap Rocket motor or something if it is delayed.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top