No throttle, but steering works..??..

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Mr.Green

New Member
Messages
2
Reaction score
2
I just did a bunch of maintenance and some upgrades to my Kraton 8S. It was running fine before I started working on it. It has all stock electronics except I just changed the steering servos. I charge my batteries, go to run it and the steering works, but no throttle. The LED on the ESC is flashing red quickly. Any ideas? Thanks
 
Thats an LVC code but in your case I’m assuming you’ve started with full batteries. ......
Im not sure if you have to rebind after an electronics swap. Hopefully some dudes with knowledge will chime in.
Good luck.

cheers,
kev
 
Sounds like you plugged the ESC in backwards into the receiver. Check the wire. White goes to the center and black to the edge.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top