Outcast Not a good start!!
- Thread starter martin34
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 2,635
- Reaction score
- 6,031
- Location
- Gimli Manitoba
- Arrma RC's
- Kraton 8S
- Kraton 6s
- Kraton EXB
- Outcast 8s
- Outcast 6s
- Vorteks
That’s poopy. I beat the hell out of mine more times than I can count. Never broke anything yet.
- Messages
- 2,635
- Reaction score
- 6,031
- Location
- Gimli Manitoba
- Arrma RC's
- Kraton 8S
- Kraton 6s
- Kraton EXB
- Outcast 8s
- Outcast 6s
- Vorteks
I put speed pinion on before I even ran it. Lol.
- Messages
- 6,083
- Reaction score
- 13,924
- Location
- UK..
- Arrma RC's
- Infraction
- Mojave EXB
- Outcast 8s
- Outcast EXB
- Talion EXB
- Typhon 6s
I put a 25T on before I'd even run mine..!! ????
JsyOutcastOwner
Fairly New Member
I landed mine wrong from a jump and ended up buckling my front, right suspension bar! *OUCH* ? ?
The pins are 3.5mm. I bought these and cut them to size: https://www.amazon.com/dp/B07KY9RQ7K/ref=cm_sw_r_cp_apa_fab_YX6zFbMW8ZP96
I had to JB Weld mine into place because the head of the dogbone had a crack through it. So, I can't guarantee they fit without needing the JB Weld. But they seem pretty sturdy. I only ran them a few times and then my GPM shafts showed up.
I had to JB Weld mine into place because the head of the dogbone had a crack through it. So, I can't guarantee they fit without needing the JB Weld. But they seem pretty sturdy. I only ran them a few times and then my GPM shafts showed up.
