Outcast Outcast 4s v2 drivr shaft for v1

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

zizi8862

Active Member
Messages
129
Reaction score
86
Location
New Zealand
Arrma RC's
  1. Kraton EXB
  2. Outcast 4s
Not sure if its been asked but does the new out drive work for the v1. Also a few parts I'm looking at replacing on my v1 with the v2 is the new metal diff. Anyone tried and any other rec for changing
 
Not sure if its been asked but does the new out drive work for the v1. Also a few parts I'm looking at replacing on my v1 with the v2 is the new metal diff. Anyone tried and any other rec for changing
What do you mean by outdrive?
The v2 differential and input gear will work fine in your v1. If you’re talking about the center driveshaft, it may be too long for your V1 since the V2 outcast has a slightly longer chassis. Maybe it will squeeze in but I’m not sure.
 
Center shaft is longer due to the longer chassis, drive axles are longer as well.. would need to switch out the arms if you plan to run the newer drive axles..
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top