Outcast Outcast 4s wont move

[Jaketerry1995]

My Outcast 4s is less than a week old. Its been running fine until i gave it full throttle and it landed on its back. I still have steering, bit when I went to give it throttle the motor whiles up and sounds like its spinning but not moving. I checked the diffs and both seem to be fine. Does anyone have an idea what it could be. I thought maybe the pinion came off.

 

[ph47mf]

sounds like either a loose pinion gear or loose slipper clutch.

try the clutch first as that doesn't involve taking the motor out.

 

[Rad369]

Check motor pinion That was my 1st problem

 

[Jaketerry1995]

sounds like either a loose pinion gear or loose slipper clutch.

try the clutch first as that doesn't involve taking the motor out.

I thought about that but with being newer to rc and my first arrma i would chrck before i dove into it

 

[Rad369]

Tighten slipper look on forum for Correct way you will need Lock tight

 

[VonJarga]

Pinion gear grub screw was loose and slipped out of place. Just realign it and locktite it back down.

 

[Outcastblxnut]

Slipper clutch is loose. Tighten her up and loctite it