Outcast Outcast exb 6s not working

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Saladfingerz

Active Member
Messages
77
Reaction score
94
Location
Ohio
Arrma RC's
  1. Outcast 6s
  2. Senton 3s
  3. Vendetta
I was out running my outcast earlier and it just stopped moving. I thought it may have overheated so I brought it inside too cool down. Just tried it again after a 2 hr cool down and still nothing. Everything turns on the fans, esc and even the lights I have on it. But the car won't move. I still have steering though. Nothing is grinding or anything so the motor isn't even rotating when I throttle it. Could my motor be burned out?
 
Are your motor connectors connected properly?
Is the solder still good? With this heat + the heat from the amps, it wouldn't surprise me if the connection was weakened a bit
 
Are your motor connectors connected properly?
Is the solder still good? With this heat + the heat from the amps, it wouldn't surprise me if the connection was weakened a bit
I was hoping it was maybe a connector that came undone but it's not. I hooked up an esc from another car to my outcast and the motor runs fine so its gotta be the esc that's gone bad.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top