Outcast Front Dirt Guards Talion V3

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

JMS RC

Active Member
Messages
231
Reaction score
639
Location
Sweden
Arrma RC's
  1. Infraction
  2. Kraton 8S
  3. Kraton 6s
  4. Kraton EXB
  5. Nero
  6. Outcast 6s
  7. Talion
  8. Typhon 6s
  9. Typhon 3s
Hello, has anyone successfully installed the Outcast Front Dirt Guards AR320376 on the Talion V3 ?
The bodyposts are in the way and the height of the dirt guards is just to high to fit the body in the stock position. Modify bodypost and cut down the height ?
 

Attachments

  • IMG_1977a.JPG
    IMG_1977a.JPG
    112.4 KB · Views: 106
  • IMG_1978a.JPG
    IMG_1978a.JPG
    115.1 KB · Views: 64
That would be interesting. I don't see a lot of dirt getting in there on mine. The Talion body does a good job of keeping most of it out.
 
Been reading that these Outcast Dirt Guards takes away some of the cooling/airflow but i just hate the debris and little rocks, so i decided to install them anyway. Used M4x16 to mount the plate and trimmed the bodyposts, trimmed about 5mm off the height of the dirt guards so they don't rub against the body. Another way is to raise the bodyposts but i wanted to keep the body stock height.
Worked great at todays bash and i did'nt notice any problems with the motor temp.
 

Attachments

  • 1.JPG
    1.JPG
    188.4 KB · Views: 68
  • 2.JPG
    2.JPG
    197.8 KB · Views: 69
  • 1a.JPG
    1a.JPG
    178.7 KB · Views: 58
  • 2a.JPG
    2a.JPG
    158 KB · Views: 57
  • Temp.jpg
    Temp.jpg
    198.2 KB · Views: 59
Last edited:
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top