Outcast Outcast v2 problems with the steering, goes left or right if

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Humblebeast72

Active Member
Messages
41
Reaction score
49
Arrma RC's
  1. Mojave EXB
  2. Outcast 4s
  3. Outcast EXB
Don't understand why my truck doesn't steer straight. Servo saver is aligned with the arrow, steering trim was centered, set end points, set the trim to the direction it was veering off to...to atleast see if it centers and still goes left or right when it wants. Any help would be appreciated highly cause this is frustrating to say the least.
 
Look over all the bearings and tie rod ends. Check for slop. May just be something worn out.
I just finished checking tie rods,bearings are new,car is new as well, i changed the servo/servo saver to 25t spline from the 23tsaver and stock servo. tried changing to different servos and savers and nothing...thinking about going back to stock and see if it work better that way idk 🤷🏻‍♂️ so annoying
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top