PPS 6s V4 Differential Cap

[Lovestricken]

It's a new great product. Once the flood stops it will be easier to do smaller runs. Keep up the great work

 

[olds97_lss]

Thanks WoodiE!

I figured you're kidding, but that's how I feel. Gotta have the things to sell to sell the things!

 

[crimsonfancy]

I noticed that, I’m pretty savvy tho...
I couldn’t wait and had to put it on immediately!! ?
View attachment 67591 View attachment 67592 View attachment 67593 View attachment 67594 View attachment 67595

That looks fine as a mfr!

Works awesome with driveshafts, I bet.

 

[adidas303]

Ditto!

 

[crimsonfancy]

That looks fine as a mfr!

Works awesome with driveshafts, I bet.

Quick off topic @Hammer Down. Is your center diff case de-anodized or did you purchase one that I haven't seen?

 

[Hammer Down]

Quick off topic @Hammer Down. Is your center diff case de-anodized or did you purchase one that I haven't seen?

It’s the two piece HR one that I de-anodized with caustic soda. It does look pretty trick tho huh?

 

[crimsonfancy]

It’s the two piece HR one that I de-anodized with caustic soda. It does look pretty trick tho huh?

Yep! ?

 

[Outcastblxnut]

I'll admit, it may take a little time to finger out. I really need to start making instructions. It CAN go together a few different ways, but only works one. haha. There is a Skinny and a Fat side. Everything that is Skinny bolts on the right side of the PPS text. Everything Fat goes on the left. It'll match the motor mount/diff mount thickness when it's done.

I also recommend tightening the bearing retainer blocks last, once the cap is tight. I left some play in them for allowing things to line up perfectly, but if you tighten them first you could have difficulty installing.

Hell with instructions we need decals?

 

[MaddogMikeD]

That sheer beautiful artwork... almost a shame to get it muddy...
P

Looks badass guys!!!

All thanks to you....

 

[crimsonfancy]

That sheer beautiful artwork... almost a shame to get it muddy... View attachment 69610 View attachment 69611
P

All thanks to you....

Lookin' awesome! Can't wait to fit my stuff from PPS and I've received the whole kit. Hopefully early next week I can sit down and get after it. Going on the Mojave first and probably gonna need it for the Noto next. We'll see.
Thanks for showing??...every time I see I'm more motivated.
PS: Please make some sweet decals, PPS!

 

[Outcastblxnut]

Got mine today?

 

[The Donut Man]

Would somebody mind confirming the bolt hole spacing of the diff cap for me? I already have the M2C motor mount and I want to use this top plate to bridge the two, but I want to be absolutely sure it fits before ordering. I measured 30mm between holes front-to-back and 21.2mm between holes side-to-side. I think the M2C mount uses the bolt pattern of the V1-V3 center diff covers, but I don’t know if the same bolt pattern is used for the V4-V5. Thanks in advance!

 

[elschizo]

Bolt Pattern is the same. .

 

[Kingleo619]

Can you do a 40x40 low profile fan mount? I would preorder now. I seen some but they in the u.k shipping is $25 for $15 mount