PPS Grublock Mount W/ Spektrum 780KV Brushless motor

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

kyoto

Member
Messages
24
Reaction score
20
Location
Washington
Arrma RC's
  1. Kraton 6s
  2. Mojave
  3. Typhon TLR
Considering upgrading my Mojave to 8S with a 1/5 scale motor. Looking at the Grublock motor mount from PPS to mount the motor but the website doesn't directly say if it can support 1/5 motors and horizon hobby only provides the outer diameter of the motor. Anyone knows if it can?
Grublock Motor Mount for Arrma 6s BLX Platform
1648760209813.png
 
I would contact PPS if you are unsure.
But I am sure someone else has done this and will chime in.
My gut says it will be fine. Just not 100% sure.
It isn't really that large (diameter) of a 1/5 motor as motors go. The motor's mounting plate compatibility is what matters most.
 
PPS sells both 25 and 30mm mounting hole plates for it you need to tell them when you order. Just a warning the don't make a 35MM plate so you will have to stick to smaller/older motor cases from some places like TP V3 is 35mm on there 56xx were and there V2 is 30mm.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top