Programing Card Help!!!!!!!!!

[Sswwiiss1]

Hello everyone!

Im trying to program my 25amp ESC on a 2S Lipo with a program card and when I plug it to the ESC all of the red lights light up but it keeps flashing the blue light (Work State) but it will not let me program or choose different options. Can anyone help or know why ?

 

[pug]

What RC and ESC are you talking about?

 

[Sswwiiss1]

What RC and ESC are you talking about?

GoolRC 4800kv brushless motor and 25amp ESC

 

[slick2500]

GoolRC 4800kv brushless motor and 25amp ESC

I don't think you can use the card on the 25amp esc.

-edit- I lied it looks like it is supposed to work.

【The operation steps of programming in ESC for brushless motor】
1. Turn off the ESC and disconnect the throttle lead from the receiver.
2. Connect the throttle lead from the ESC to the 3 pin signal connector on the Program Card. (If the ESC is without BEC, please also connect a 4.8V-6V battery to 3 pin batt.connector.)
3. Turn on the ESC to apply power to both ESC and Program Card.
4. All current settings will be displayed on the correspond LEDs.
5. Press up/down button to move between settings.
6. Press left/right button to change the value for that setting.
7. Press Load Default button to return to default setting (if necessary).
8. Press OK button to save this setting

 

[Sswwiiss1]

I will try this. Thanks for your help!

I don't think you can use the card on the 25amp esc.

-edit- I lied it looks like it is supposed to work.

【The operation steps of programming in ESC for brushless motor】
1. Turn off the ESC and disconnect the throttle lead from the receiver.
2. Connect the throttle lead from the ESC to the 3 pin signal connector on the Program Card. (If the ESC is without BEC, please also connect a 4.8V-6V battery to 3 pin batt.connector.)
3. Turn on the ESC to apply power to both ESC and Program Card.
4. All current settings will be displayed on the correspond LEDs.
5. Press up/down button to move between settings.
6. Press left/right button to change the value for that setting.
7. Press Load Default button to return to default setting (if necessary).
8. Press OK button to save this setting