Proline badlands and beadlocks mod.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Streetsports

Active Member
Messages
209
Reaction score
285
Arrma RC's
  1. Limitless
  2. Kraton 8S
I used the ones for the x-maxx. I used a stepped drill bit to open up the mounting hole.The x-maxx has the same size hex but much smaller aluminum stub. I have another hobbywing system for the x-maxx on the way.

20200211_175605.jpg

20200211_195525.jpg
20200211_195615.jpg
20200211_200258.jpg
20200211_200303.jpg
20200211_200325.jpg

20200211_200849.jpg
20200211_200902.jpg

20200211_201428.jpg
 

Attachments

  • 20200211_201458.jpg
    20200211_201458.jpg
    167.7 KB · Views: 106
  • 20200211_201508.jpg
    20200211_201508.jpg
    229.6 KB · Views: 111
  • 20200211_201522.jpg
    20200211_201522.jpg
    217.2 KB · Views: 107
Last edited:
Niiiiiiiiiiiice!!!! Maybe one day mine will look like that. What’s your favorite?
x-maxx. Tons of power, indestructible and it jumps like a 1/8 buggy. This is my 2nd one. 1st one only ever broke the front bumper mount and front bulkhead after 2 years of beating on it.
 
Last edited:
Did the holes come out dead balls accurate? :LOL: Would hate to see wheel wobble..
They did. The wheel already had a slight step. almost like the mold worked for both sizes of axle. The stepped drill bit was the key though. If the holes were off at all it seems the hexes straightened them out
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top