RadioLlink rc6gs telemetry useless?

[QLynxer]

So I hooked up the telemetry wire to my Radiolink receiver.

Pretty cool to see battery voltage on the transmitter but once i went to bash it kept beeping at me every time I was heavy on the throttle.

It would beep and say low power EXT.

Is there a way to turn down the sensitivity or should I unplug it completely?

 

[WyldCFH]

I have found it useless so far. My battery was below 3v/cell and I was still seeing 24v from a 6S

You can turn the alarms off and adjust the thresholds in the TX menus

 

[slick2500]

It would probably be more useful on something like a crawler, I never pay attention to mine in my Kraton EXB.

 

[SrC]

Voltage Telem works great on my Lim. setup.
You didn't set the Telem alarm voltage setting correctly at the Radio. Trust me it works.
Sure it will be a nuisance if not set correctly.

 

[QLynxer]

Voltage Telem works great on my Lim. setup.
You didn't set the Telem alarm voltage setting correctly at the Radio. Trust me it works.
Sure it will be a nuisance if not set correctly.

What do you have it set at?

I have mine set to 21volts so 3.5v per cell.

 

[SrC]

Remember that some lipo cells will drop below the rest. The telem lipo voltage is only an approximation of the average volts per cell. I would be more conservative when setting the voltage. Set it higher/lower if need be. Use a lipo checker to help fine tune it if need be.

 

[Jerold]

What do you have it set at?

I have mine set to 21volts so 3.5v per cell.

You might try a lower setting. I believe my Slash has a factory LVC is 3.2V. After I pull the batteries they are around 3.4-5 after resting for a bit.

I don't run LVC on the Limitless.