Kraton Rear chassis side mud guards?

[Garcbomber]

With the dust cover

View attachment 411602

View attachment 411603

Solid integration, I'd wrap a piece of duct tape or good elastic velcro around the back underneath chassis for good measure. That area might see a vortex swirl of debris

 

[Barmaleus]

@Garcbomber Agree, need to do something like that. Planning to test tonight as is and see what happens. Then customize further

 

[Barmaleus]

Tested yesterday - lots of (cold and wet ) grass exactly at the spot where MUDD and mud guards meet. Makes sense, as this where the flow is directed right now. Need to work on addressing it. Inside the chassis was pretty much clean.

Oh, and the motor fan stopped working... Sigh.

 

[Chapinb]

Slow day at work and did some measurements from photos. Looks like the M6 side guards should fit the K6 chassis. Wont fully seal the side or bottom, but should block most debris.
Dosent look like screw holes line up.
Anyone have the parts to verify?

 

[Garcbomber]

Slow day at work and did some measurements from photos. Looks like the M6 side guards should fit the K6 chassis. Wont fully seal the side or bottom, but should block most debris.
Dosent look like screw holes line up.
Anyone have the parts to verify?

Mounted 6S mojave side skirts trimmed on my Talion EXB chassis 1/8th Mojave build, a few holes line up and the rest I drilled/tapped with nylock nuts to contain.