Rear Wheels wont turn, motor does but not wheels.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

PMB1013NJ

Member
Messages
8
Reaction score
0
Location
Port Republic, NJ
Arrma RC's
  1. Granite
I have done all kinds of trouble shooting and in the end the problem is in the gear box. I have taken the truck almost entirely part and cant figure how to get into the gear box. Any help would be greatly appreciated.
 
Hi

I just did a thread on removing the tranny, and too open the tranny up you will have either 6 or 7 screws on one side of the tranny and depending on what version of the tranny you have.

The BLX Tranny will have 7 screws holding the tranny case together.
IMG_2341.JPG
 
Last edited:
So I was looking and fiddling around with the truck and saw a tiny screw on the sprocket attached to the motor. I got a tiny screw driver and tightened it and wah lah runs like a champ. I feel so stupid.
 
Hello,

I have buyed a granite bls, fantastic car.
Can anybody tell me the richt tightining off the slipper clutch. The shop where i buy the car told me to full tightining the clutch and dan turn 1/4 circle back.
Is this right?

Thanks for the reply.

Mark
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top