Kraton Savox 1210 and upgraded mount issue

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

83N

Active Member
Messages
137
Reaction score
49
Points
128
Location
UK
Arrma RC's
You guys that have the Savox 1210 and an after-market mount:

Do you have an issue with the servo cable exiting the servo body at the same height as the centre drive shaft? Mine looks like it's about 1mm from the shaft and that's if I go up and over the chassis brace - it won't go the stock route of under the brace and I'm sure that can't be right?

Appreciate any input.
 
Is the servo sitting on the chassis? It should be. I run my wires between the post and servo then back to the receiver box, over the chassis brace.
 
I used the supplied rubber dampers and aluminium reinforcers so it's a little raised up from the chassis. Did you attach the servo directly to the new mount to get it as low as possible?
 
Last edited:
After removing the vibration dampeners it all became obvious - thanks for the help, OF.
 
Back
Top