Savox/HR servo mount install help!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Please shed me some light on those body mounts with the knurled cap? I am sick as poop with those pin types, already........ A part number or a link would having me order them within minutes of getting the info. Thanks and some beautiful work shown in this thread.....damn.

I am guessing you were referring to these:
PROLINE 630500 Mounted (Ten-SCTE, SCTE 2.0) Extended Front and Rear Body
https://www.amazon.com/dp/B00DZOVFFW/ref=cm_sw_r_sms_c_api_i_cI32Cb2JZ4SYY

A bic pen was used to make up the difference of the shaft diameter - absolutely perfect fit.
9A4FF08F-BA2F-468F-AB0B-E6345975AC86.jpeg
751E691D-D61B-4582-BDF8-B43D23551F1F.jpeg
 
What hardware did you guys use to secure the HR servo mount to chassis? When I tried using the original hex screws that secured stock servo mount, I could not get the screws to fasten all the way. What am I doing wrong? Please help...
 
Nevermind...found some shorter screws which did the trick. Now just need to find a longer screw and spacer to connect servo saver to steering link
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top