Outcast savox sw-1210sg w/ glitch buster

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Armydad72

Fairly New Member
Messages
23
Reaction score
5
Arrma RC's
Really stupid question but were in the blue hell do i plug in the glitch buster in my outcast. LOL I think slot 3 but not sure. and is tehre any thing else i need to do besides plug and play.

Thank you for reading and hopefullly answering my stupid question.
 
I can't get it to work do I need to do something else to the truck for it to work?
 
I used industrial strength Velcro on the chassis brace.
Little piece on the brace, little piece on the buster, and voila.
As TobyJ noted, any open port will do.
Just ensure you have the polarity right.
The black wire is at the outer most pin slot on the rx.
You'll notice there is no ground...just a pos and neg wire.
I used the B port on the receiver...which is where you would normally plug in a stand alone BEC if the one onboard the ESC wasn't up to task.

IMG_0844.JPG
 
I used industrial strength Velcro on the chassis brace.
Little piece on the brace, little piece on the buster, and voila.
As TobyJ noted, any open port will do.
Just ensure you have the polarity right.
The black wire is at the outer most pin slot on the rx.
You'll notice there is no ground...just a pos and neg wire.
I used the B port on the receiver...which is where you would normally plug in a stand alone BEC if the one onboard the ESC wasn't up to task.

View attachment 8225
Where do you get industrial strength velcro?
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top