Screws won't open

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

WildP1

Member
Messages
28
Reaction score
2
Arrma RC's
  1. Senton 6s
Hello
I just got my new fazon and want to replace a broken axle. The problem is, that the screw that holds the small rod in place doesn't loosen up. I've read that I have to heat it up and then try it again but are there any other solutions?
Thanks
 
Right, what you describe sounds like loctite or other screw lock.
If you make the screw hot, then the doc liquid will get loosen.
Same like the pinion gear....

Regards,
lonee
 
Right, what you describe sounds like loctite or other screw lock.
If you make the screw hot, then the doc liquid will get loosen.
Same like the pinion gear....

Regards,
lonee
Ok thanks!
 
For the thread locked screws on the Nero I press a soldering iron into the head of the screw for 2 minutes and then quickly use a hex wrench to loosen the screw. I've tried 1 minute of heat. 2 minutes works better.
 
Thats depends of the power of the solder iron. But it will work!
Heat air or an small propane burner/solder is also working.
The tool follows the function! ;)
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top