Senton Senton 3S T-Bone racing front & rear bumper instructions...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

mikeshandssay

Member
Messages
177
Reaction score
88
Arrma RC's
  1. Limitless
  2. Senton 6s
Does anyone have them? It doesn't seem complicated, but in the end I was left with 2 aluminum spaces that only the small screws would fit through.

Any ideas? I can post pics if needed.

Thanks!
 
aluminum spacers are there to fill the gap between the lower rear bolt recess and the bumper.. ?
 
aluminum spacers are there to fill the gap between the lower rear bolt recess and the bumper.. ?

Right! I think I got that part... but they sent me TWO for the front and TWO for the rear.

It seems too tall to stack both, so I just used 1...

Does that make sense? In the end I'm left with 2 of the spacers used and 2 of the spacers not used.
 
Right! I think I got that part... but they sent me TWO for the front and TWO for the rear.

It seems too tall to stack both, so I just used 1...

Does that make sense? In the end I'm left with 2 of the spacers used and 2 of the spacers not used.

most likely they just put 2 to many in the package..?
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top