While driving my granite 4x4 the servo seems to lock up in a full right turn. I powered off the car and transmitter and it will not realign. After I removed the servo saver and put it back on with the correct alignment it runs fine for awhile. This has happened the last three times I have run it. Does anyone know what is causing this. I am rather new so I don’t know a lot about it. Thanks
Granite Servo issues
- Thread starter JShipman5
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
The servo saver isn't tight enough....unfortunately it is adjustable unless you run a screw through the split bushing portion and tighten the bushing around the triangular piece. If you do this, make sure it isn't too tight. Been through this too.
BlurTheLines
Member
- Messages
- 39
- Reaction score
- 19
- Arrma RC's
- Senton 6s
Kimbrough makes a good servo saver that should work a little better than the stock one. I've also read of other users putting a long screw through the back of the servo saver / horn to limit how far it can move. Not tightening it too much...just limiting it a tad. So it it's not quite so quick to pop out of place.
