Kraton servo weak with a new one

[RCROD]

I'd swap the bellcrank bushings out for bearings and shim while you're doing all this...it allows the servo to move more freely. I noticed a difference in the amount my servo mount flexed after doing this...it doesn't flex as much now which tells me the slop and slight misalignment it caused was stressing my servo. It was working more than it needed to before...steering is a little faster now as well.

I'm replacing my stock steering bushings with some Fast Eddy bearings. What size are the shims for the bellcrank (6x10 shims)?

 

[Mongoose]

These are the shims I used, didn't use any 5mm because they won't fit but did use four 6mm shims. Not sure on OD.

https://www.amainhobbies.com/losi-5mm-6mm-metric-shim-set-losa6356/p5827