Senton Silverado Body on Senton/Street Truck.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

LudeNation

Active Member
Messages
138
Reaction score
204
Location
Texas
Arrma RC's
  1. BigRock 4x4
  2. Granite
  3. Infraction
  4. Notorious
  5. Senton 3s
*HELP NEEDED* How can i get the back of the Silverado body to sit lower, like the picture below? I have Pro-Line body mounts. What i want my truck to look like.👇
FB_IMG_1650552326456.jpg
How my truck sits rn with a rake👇
20220519_133826_remastered.jpg
MM away from touching the shock towers so i cant go any lower.
Any ideas,tips or tricks other than raising the front posts?
20220519_135207.jpg
 
Is the body post at it's lowest position if not you just going to have to cut the body i little it lower it
 
Is the shock tower touching? Or is there space between the body?
If there's space, lower the posts until the body touches. If the body is low enough for you, drill new holes in the body post at that height.
 
Last edited:
you've got few options, first i would try to raise the front mounts so the body would sit parallel to the chassis, then lower both ends using less preload on the shocks.

Another more expensive option would be to use the Vorteks shocks and towers, they sit much lower so you'll be able to lower the body
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top